|
|
|
| The standard control panel is manufactured
from powder coated sheet steel and is fitted above the alternator
on anti-vibration mountings. |
| The control panel is equipped as follows: |
| a. |
Instruments
Voltmeter
Ammeter
Frequency Meter
Hours Run Meter
Coolant Temperature Gauge
Oil Pressure Gauge
Battery Condition Voltmeter
|
b. |
Controls
Start/Stop Keyswitch
Voltmeter Phase Sel Switch, 7 Pos
Ammeter Phase Sel Switch, 4 Pos
|
c.
d.
|
Shutdown
Protection Devices with Indicators for
High Coolant Temperature
Low Oil Pressure
DC and AC Wiring Looms
DC and AC wiring looms utilizing Industrial type multi pin
connectors, thus permitting fast fault finding and simple
retrofitting of alternative or remote control panels.
|
DG Set Control Panel 30 - 500 KVA |
| AUTOMATIC MAINS FAILURE CONTROL
PANELS |
Auto Synchronising & Auto Load Sharing Panels at Siemens
Instruments, Bangalore. |
The automatic mains
failure control panel is designed to constantly monitor the
mains supply. Upon full or partial failure of the mains, the
control panel will automatically start the generator, and supply
the load until the mains supply is fully restored. The control
panel will then disconnect the generator from the load –
reconnecting the mains supply – and allow the generator
to run off load for cooling. The control panel will then be
ready for the next mains failure.
The standard automatic mains failure control panel is a self
contained unit which is supplied loose for floor or wall mounting
adjacent to the customers mains switchboard or Alternatively,
the panel may be fitted directly to the generator. |
| The spilt system automatic mains
failure control panel or automatic transfer switch is similar
to the standard system except that the control module, instruments
and indicators are mounted on the generator and the changeover
contactors are fitted in a separate panel which is normally
installed adjacent to the mains switchboard. |
| MANUAL OR AUTOMATIC SYNCHRONISING
WITH AUTOMATIC LOAD SHARING |
| The control panel is normally divided into vertical
sections with one cubicle for each generator and one cubicle
containing the combined output busbars and combined output circuit
breaker when fitted. |
Micro Processor based remote panel
for 3 X 1 MW DG Machine |
|
